Yes! and with automatic version it is also possible to interface with your computor network.

 

Standard tensile,proof and hold tests can be performed and as an option fatigue tests.

 

Our testing machines are designed primarily for testing wire rope slings but other items of lifting gear can also be accomodated by employing schackles etc. in the attachment.

 

By using a TALURIT hydraulic cutter. See hand tools.

 

The TALURIT product range includes low weight hydraulically powered cutters to cater for steel wire ropes upto 100 mm diameter.

 

Yes our type LKA 26 PS employs shear blades to give a clean and quiet environment.

 

By using our annealing and twisting off machines type AV.

 

With the maximum length of 500 mm you can reach +-1 mm.

 

Our UK operation has all necessary knowledge, documentation and equipment to service and repair old CCL Talurit machines.

 

Please contact our UK office!

 

It is likely that there is a loss of the high pressure function which may be the result of worn out O-rings in the valve house or if there is oil leakage from the main ram then the cylinder seals may require replacing. Please consult us.

 

Loss of this function may be due to either an electrical or hydraulic malfunction.To test electrics press the solenoid No 1 and if piston functions normally then check connections on circuit board and foot pedal.If the piston remains stationary it is likely the “O”rings in the valve housing require replacing , please consult us for instructions etc.

 

With standard type wire rope constructions our 300t press will press upto Code 22T (24 UM )single bite and Code 30T (32 UM) multi-bite.

 

Yes, as an alternative to the vertical position the press can be laid on its back giving easy access to the die pocket.

 

Yes, in our standard range we have hand pumps, foot pumps, air-hydraulic pumps, motor pumps and portable hydraulic power packs.

 

You have been overloading the dies,adjust the press loading for the size of ferrule to be pressed.

 

Ensure the die bore is regularly lubricated prior to pressing the ferrules.

 

Yes, with either round or hexagonally shaped bores in the dies it is possible to swage SS terminals corresponding to US mill spec up to approx 6 mm wire rope in several stages depending terminal length.

Our 30t single pillar press with a 1,5 or 3 kW hydraulic unit is most suitable and economically priced.

Visually check for surface damage, measure bore (both halves together) and contact us with bore dimension for advice.

No,the die profiles and heat treatment is different.

The die is probably damaged, consult us.

Yes but you can not reccon upon to reach full strength of the termination. With our SYNCRIMP ferrule you can swage nylon ropes and reach about 30-50% of the maximum strength of the rope.

A. By using our type TKH ferrule which incorporates an inspection hole to confirm rope position inside the ferrule.

Please contact us for recommendations.

Measure the actual rope diameter using a vernier.

Yes, with either round or hexagonally shaped bores in the dies it is possible to swage SS terminals corresponding to US mill spec up to approx 6 mm wire rope in several stages depending terminal length.

Our 40t single pillar press with a 1,5 hydraulic unit is most suitable and economically priced.